SpeedFactory Racing Toyota MR2 / Celica Titanium Exhaust Manifold Stud Kit

SF-02-063-8
Available for Order
$111.99

$111.99

SpeedFactory Racing Toyota MR2 / Celica Titanium Exhaust Manifold Stud Kit

SpeedFactory Racing's Toyota MR2 / Celica Titanium Stud Kits are made of ultra-strong Ti 6Al-4V and incorporate a 4mm hex key tip that allows them to be easily installed using an Allen wrench. Titanium 14mm 12-point nuts and washers are included.

The use of factory manifold bolts and studs, especially with an aftermarket header/turbo system, can result in stripped or broken bolts and inadequate clamping force, resulting in leaks. This stud kit looks great and will allow you to properly clamp your exhaust manifold to the cylinder head without experiencing sealing problems, common stud/nut failure, or ugly and troublesome rust and corrosion.

Titanium is ~45% lighter, stronger, and will not corrode like your stock steel bolts or studs!

Each stud/washer/nut assembly weighs only 14g!

This kit incluces the following:

(8) M10 x 1.25mm x 55mm titanium studs

(8) 12-point M10x1.25mm titanium nuts

(8) M10 titanium washers

Available in standard or burnt titanium finish.

These studs fit the following applications:

Toyota Celica (1985-1998) with 3SGE/3SGTE engines, including All-Trac Turbo and GT-Four models

Toyota MR2 (1990-1999) All Models

If you are not sure if these studs will work with your engine, please email support@speedfactoryracing.net or call us at (253)566-4331.

Read More
Read Less
The cookie settings on our website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site!

Your cart

×
}