Buy Now, Pay Later Starting at 0% APR

USE CODE SF10 FOR 10% OFF YOUR ORDER! SOME BRANDS EXCLUDED

×

Hybrid Racing Shifter Cables RSX, Civic, and Integra

Hybrid Racing
SKU-2991
Available
$329.00

$329.00

Hybrid Racing Shifter Cables RSX, Civic, and Integra
This is for a set of 2 cables.

Hybrid Racing's Shifter Cables are designed to be a direct replacement for OEM RSX style shifter cables.

These cables feature Stainless steel push rods, swivel support tubes, and inner cables. The rod ends and mounting bushings are all 6061 aluminum that has received a T6 heat treatment and a black, hard anodized coating.

These cables are designed to be upgraded replacements for the OEM cables. The solid rod ends and bushings give the Hybrid Racing cables a firmer, tighter feel over OEM RSX cables. In addition, the plastic swivel support tubes that are known to break on the OEM cables have been replaced with stainless steel swivel support tubes, which are significantly harder to break.

The Hybrid Racing shifter cables are slightly thicker than OEM cables and will fit a K Swap with little extra work. Some extra effort may be required to install these cables into an RSX as the rubber grommet that goes around the OEM cables will have to be retrofitted to accept the thicker Hybrid Racing cables. It should be noted that the OEM cable that is controlled by the right/left motion of the shifter has a plastic twist-lock bushing on the shifter end. Hybrid Racing cables instead use a spring clip and aluminum bushing. This aluminum bushing simplifies installation a bit, but more importantly, it gets rid of yet another plastic part that tends to flex on the OEM cables, leading to a sloppy feeling shift. The extra spring clip that you will need to install the Hybrid Racing cables is included with the cables, so you will not need to buy any other parts. An easy to follow installation tips sheet is included with each set of cables to make instillation as worry free as possible.

If you are using the Hybrid Racing cables on an OEM-style shifter mounted to a Karcepts adapter plate in a K swapped chassis, you will need to widen the hole for the cable that is controlled by the front/back motion of the shifter where it goes through the Karcepts adapter plate. The hole needs to be widened to approximately 3/4" diameter. A stepped drill bit works well for doing this.X
Read More
Read Less
The cookie settings on our website are set to 'allow all cookies' to give you the very best experience. Please click Accept Cookies to continue to use the site!

Your cart

×