Tuning
We have successfully tuned hundreds (650+) of satisfied customers over the past few years, ranging from 150whp-300+whp N/A builds, to 200whp-700+whp turbo builds. You can rest assured that we have the knowledge and experience to properly tune your vehicle!
Check out the Graphs section for dyno charts.
.JPG)
Our Dynapack AWD dyno is capable of load control, and we tune all partial throttle AFR's (where you spend 90% of your time driving) as well as wide open throttle while on the dyno. This results in a complete tune offering unmatched partial throttle driveability as well as excellent wide-open throttle performance!
We are EFI University Certified and currently offer tuning with the following systems:
Neptune RTP
Neptune EEPROM(Authorized Neptune Dealer/Tuner)
Crome
Hondata S300
Hondata K-pro
Uberdata
We also offer ECU chipping services, and keep a good stock of the items below to cover your tuning needs. Please consult with us about your specific setup.
- OBD0 to OBD1 conversion harnesses
CLICK ABOVE FOR PRICING
- OBD2 to OBD1 conversion harnesses
CLICK ABOVE FOR PRICING
- NGK spark plugs in various heat ranges
CLICK ABOVE FOR PRICING
- MAP sensors
CLICK ABOVE FOR PRICING
- Boost controllers
CLICK ABOVE FOR PRICING
- JDM & USDM ECU Chipping kits
We are now offering PWM boost control packages for Neptune eeprom, Neptune RTP, and Hondata S300 systems. The package includes boost control/pwm hardware added to the ecu, boost solenoid, fittings, vacuum lines and installation for $150.00! This will allow boost by gear and rpm control! This is the ultimate way to control boost for street cars, as well as track cars.
Dyno Tuning: $160/hr
You must call and schedule dyno time at least 1 week in advance. In most cases, we must see the car in advance to make sure everything is up to par before the date of the Dyno Tune.
Typical tuning time is 2 to 3hrs for simple setups. Cam gear adjustments, tuning multiple boost levels, race gas tuning, etc. take additional time. Please contact us to discuss your particular setup.
Any delay in the tuning process caused by charge pipes blowing off, non-functioning wastegates, bad thermostats, etc. will result in an additional $50/hr fee. Your vehicle must be ready to tune, with no unresolved issues or check engine lights. Any issues which need to be addressed will be fixed at $75/hr.
* Please make sure to bring your wheel lock key as it is needed to setup your car on the dyno!
Baseline Dyno Pulls - 2wd
3 pulls - $65
3 pulls with wideband 02 - $75
Baseline Dyno Pulls - 4wd
3 pulls - $85
3 pulls with wideband 02 - $95